A§E hardware setup (if you want to use A§E without audiometer or amplifier)

Plug & Play: all you need to run A§E at your desk, without the need of a sound-treated room (Calibration with a sound level meter is required once).

Otoconsult has carefully selected an optimal hardware combination for use with the A§E software. The A§E software package can be used with any standard high fidelity audio setup. But if you are looking for a solution to equip a new test environment, this package might be the best choice for you.

 

Contents of the package (small differences with depicted hardware are possible):

  • A high-end USB sound card: USB powered, 24Bit/96kHz Audio Interface
  • A pair of loudspeakers: Powerful active near field monitors. 6.5" mid/bass driver (75W), 1" tweeter (25W), shielded against computer/monitor interference, very flat response, frequency range: 50Hz to 20kHz.
  • An audio cable: 5m (20 ft.) cable to connect the USB audio interface to your the speakers.
!
 << Back